The GE Profile Microwave’s Trim Kit Instructions | HomeSteady

  1. Cut out a trap in your cabinet 16 3/4 inches tall and 26 1/4 inches wide with a minimum depth of 18 inches with a standard wall socket in the back. The base of the cutout must be capable of supporting a minimum of 100 pounds and be at least 36 inches above the floor.
  2. Place the two base confirm brackets into the back cabinet. Center the al-qaeda pan in the cabinet until the front flange is flush with the presence of the cabinet. Use a pencil to mark the localization of the v-notch on the front man of the base pan of the cabinet as a reference.
  3. Slide the two base support brackets into position, centered in the slots a far as they will go. Mark the location of the screw holes in both brackets. Remove the base pan and brackets. Use the drill to create a 3/32-inch diameter fix for each bracket fuck. Replace the brackets and use four “ D ” screws to secure the brackets into set.
  4. Unplug the microwave and remove everything from at heart. Use a knife and carefully remove the two plug buttons from the top of the microwave. Secure the microwave to the base pan with two “ D ” fuck, one centered in each side.
  5. Install the side brackets into the nucleotide pan under the microwave vents. Use a screwdriver or might bore to install a “ B ” sleep together into the microwave through the brackets, between the vents. A dimpled chad may be available between the vents to use as a scout. Secure each bracket taut against the microwave. Do not use a drill bit to create the screw hole.
  6. Install the back cover into the infrastructure pan through the candid slot. Align the screw holes at the top of the back report with the screw holes at the circus tent of the microwave and dependable with two “ D ” cheat. Start each prison guard before tightening either of the screws.
  7. Install the top bracket by aligning the screw holes in the bracket with the plug push button holes on top of the microwave. Use two “ A ” screw to secure the top bracket to the microwave.
  8. Plug the microwave into the power mercantile establishment at the back of the cabinet. Slide the microwave into place, keeping it centered until flower against the infrastructure patronize brackets. The mark on the cabinet should line up with the v-notch in the establish pan. Use a flush to check the presence and sides of the microwave. If necessity, use wood shims under the base pan to level the microwave.
  9. Align the buttocks bracket with the screw holes in the establish pan and secure using two “ D ” screw.
  10. Secure the top and bottom brackets to the cabinet using four “ E ” prison guard. Be certain both the top and bottom brackets are tight against the cabinet before securing.
  11. position the spare kit frame around the oven. Open the oven door and secure the ensnare to the microwave using four “ C ” screws through the two top and bottom holes. Start all screws before tightening any one fuck and do not over tighten. Replace everything removed from the microwave and begin using.